Which set of configurations will result in the member ports on switch 1 and 2 to bundling into an EtherChannel?
A. Switch1(inf-range)# channel-group 1 mode active
Switch2(inf-range)# channel-group 1 mode auto
B. Switch1(inf-range)# channel-group 1 mode desirable
Switch2(inf-range)# channel-group 1 mode passive
C. Switch1(inf-range)# channel-group 1 mode on
Switch2(inf-range)# channel-group 1 mode auto
D. Switch1(inf-range)# channel-group 1 mode desirable
Switch2(inf-range)# channel-group 1 mode auto
Related Courses
ROUTE – Implementing Cisco IP Routing v2.0
SWITCH – Implementing Cisco IP Switched Networks v2.0
TSHOOT – Troubleshooting and Maintaining Cisco IP Networks v2.0
Related Certification
CCNP Routing and Switching
CCNP R&S Question of the Week Series
- CCNP R&S Question of the Week: IPv6
- CCNP R&S Question of the Week: BGP Attribute
- CCNP R&S Question of the Week: Gateway of Last Resort
- CCNP R&S Question of the Week: Routing Protocols into OSPF
- CCNP R&S Question of the Week: BPDU Guard
- CCNP R&S Question of the Week: Private VLANs
- CCNP R&S Question of the Week: Blocking to Forwarding State
- CCNP R&S Question of the Week: FTP to HTTP
- CCNP R&S Question of the Week: Alerts
- CCNP R&S Question of the Week: Configuration Sequence
- CCNP R&S Question of the Week: TCP Traffic
- CCNP R&S Question of the Week: IPv4 and IPv6
- CCNP R&S Question of the Week: clear ip route
- CCNP R&S Question of the Week: IPv6 Traffic Filter Impact
- CCNP R&S Question of the Week: EtherChannel
Please support our Sponsors here :