In a multi-vendors switch implementation, a network engineer notices that directly connected devices that use CDP are not visible. Which standard protocol could be used to resolve this issue?
A. Local Area Mobility
B. Link Layer Discovery Protocol
C. NetFlow
D. Logical Link Discovery Protocol
Related Courses
ROUTE – Implementing Cisco IP Routing v2.0
SWITCH – Implementing Cisco IP Switched Networks v2.0
TSHOOT – Troubleshooting and Maintaining Cisco IP Networks v2.0
Related Certification
CCNP Routing and Switching
CCNP R&S Question of the Week Series
- CCNP R&S Question of the Week: IPv6
- CCNP R&S Question of the Week: BGP Attribute
- CCNP R&S Question of the Week: Gateway of Last Resort
- CCNP R&S Question of the Week: Routing Protocols into OSPF
- CCNP R&S Question of the Week: BPDU Guard
- CCNP R&S Question of the Week: Private VLANs
- CCNP R&S Question of the Week: Blocking to Forwarding State
- CCNP R&S Question of the Week: FTP to HTTP
- CCNP R&S Question of the Week: Alerts
- CCNP R&S Question of the Week: Configuration Sequence
- CCNP R&S Question of the Week: TCP Traffic
- CCNP R&S Question of the Week: IPv4 and IPv6
- CCNP R&S Question of the Week: clear ip route
- CCNP R&S Question of the Week: IPv6 Traffic Filter Impact
- CCNP R&S Question of the Week: EtherChannel
- CCNP R&S Question of the Week: Interface FastEthernet0/1
- CCNP R&S Question of the Week: Directly Connected CDP Devices
Please support our Sponsors here :